One would be a wonderful addition to any home or business, and it would also make a meaningful birthday or wedding gift. To fully appreciate its gorgeous design, you may either hang it on the wall or place it on a desk. This light box, on the other hand, is made out of layers of paper cutouts piled on top of each other. LED lights behind each layer give a three-dimensional illusion. I’ll show you how I constructed this light box and offer you some ideas on how to reproduce the look so you can make your own.
Make something from scratch or use a template if you’re just getting started.
As a consequence, the first step is to download the template and print it. Its height and breadth may be adjusted to accommodate any 8-by-10-inch light box (20 by 25 centimetres). You could perhaps come up with something really unique.
You’ll need 170 grammes of white cardboard that’s both robust and thin enough to let light pass through.
Begin by sketching the first layer of your design on card paper, then adding a 1 cm border around each layer. It will be much easier to connect the layers now. This is one of those places where nothing ever occurs. Please check out lightboxgoodman for more details.
Remove any layers that aren’t essential.
After you’ve done the first layer, use an X-Acto knife to remove it. Use an X-acto knife to make the most exact and sharp cuts possible on your projects.
Move the first layer to a new piece of card stock to make the second layer. After that, finish the task by applying the second coat. Repeat the technique for each layer independently after slicing them all.
The Moon and the Night Sky
I created a massive moon and stars on the last layer, which I then painted over. Using these tools, I carved out a moon and star form on a piece of foam board using a utility knife and a pin.
Adhesive should be applied to all surfaces.
Foam spacers are added between each layer to make reassembling easier. This method gives the image a three-dimensional appearance and a feeling of depth. You may now remove the foam spacers. They are identical in terms of height and breadth. My initial efforts at constructing spacers resulted in 12 25-cm-long spacers and 12 18-cm-long spacers. There should be four spacers in each layer. After that, a liberal application of superglue will hold everything together. The second layer should be positioned on top of the first layer once it has been cemented in place. Before continuing, double-check that the layers are properly aligned. Before going on to the next layer, double-check that each one is linked. click here the website you can find out the lots of information blastace Read more about topportal
